08 August 2010

15mm minis, part 2

After quite a delay, I have taken another small step towards getting my first unit done.

One of the important parts of a soldier's harness (uniform) in the Half Continent is the baldric, as this is an important means of identification for the soldier. The baldric is tinted in the colors of his realm's mottle - a specific combination of colors and patterns unique to each realm. The baldric on most Half Continent troops runs from the right shoulder down to the left side of the waist. In my limited searches, I did not find any 15mm (or even 28mm) minis with such a baldric. So, I need to make my own.


Here the troops, the first battalion on the left and parts of the second battalion on the right, with their new baldrics. I made them with blue/green two-part epoxy - the same material that is used to sculpt most minis. I had never used the material before but it is not hard to use at all. It is a bit sticky but I found that if I left it cure somewhat it is much easier to use. Using just a pea-sized bit of epoxy, I rolled it out between a small piece of waxed paper to flatten it, then waited a few minutes for it to start to cure. Then, I sliced strips off the 'pancake' of green stuff and stuck it to the mini. Easy!


If you look closely, you will see that over time the baldric is more defined. The minis on the left of the pic were first, and are not as good as the later troops.


The drummer did not need a new baldric, as the strap for his drum is just perfect. Now, I need to let the epoxy cure for a day or so, then the real fun begins - painting! But, I will need to decide what realm will have the honor of the first unit...

2 comments:

  1. A very laudable -and succesful- effort to reach 'authenticity': compliments!

    ReplyDelete